Special order, Not returnable

Zone Offroad 6 inch lift kit 2003 to 2007 Dodge Ram 2500/3500

Zone Offroad
ZON:D26N
lbs
    Delivery time:Allow 2 to 4 weeks delivery
Add to cart
  • Description
  • More

Zone Offroad Lift Kit

Important Notes!
2-piece rear driveshaft requires carrier bearing drop kit D5505Will not fit dually applications
Rear axle diameter will be 3.5" or 4", measure before ordering
Minor trimming may be required with some tire/wheel combinations. A front bumper spacer kit (D5801) is available to gain clearance if necessary
If driveline vibration is present, some 6" kits may require the transfer case indexing kit (D5805). See installation instructions (step 17) for fitment details.
Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2" taller ride height so net lift gain will be 4" over stock.
Gas models may require modification to the front exhaust crossover pipe on driver side when using the transfer case indexing ring
Featured Technology & BenefitsUnique upper and lower control arm relocation bracket design.Heavy 1/4" steel construction.
No cutting of the frame required.
High performance at a low price.

 

This new Zone Offroad 6" suspension system for the 2003-2007 Dodge Ram 2500 is performance packed and budget friendly for those looking to get 37" tires under their HD Dodge truck. The lift uses a unique control arm relocation design. Both the stock upper and lower arms are relocated to relieve angles, properly position the front axle and provide good caster and front pinion angle settings. The 1/4" steel constructed relocation brackets mount directly to stock locations and only require a few new holes to be drilled for extra support. No cutting of the frame or axle mounts is required. Stock alignment adjustability is retained. Stock control arm angles are maintained to provide a great ride, handling and control.

In addition to the control arm brackets, all the necessary additional components are included. Full-length coil springs, dropped pitman arm, track bar relocation, sway bar relocation and bump stops are included. The rear kits feature new lift blocks and u-bolts. A rear carrier bearing drop kit is available also for trucks featuring a stock 2-piece rear driveshaft.

This product fits the following applications:
06-07 Dodge/Ram Ram 1500 Mega Cab 4WD Gas
03-07 Dodge/Ram Ram 2500 4WD
03-07 Dodge/Ram Ram 3500 4WD

 

Quick Specs
Front Lift Height: 6″
Front Lift Method: Coil Springs
Rear Lift Height: 4″
Rear Lift Method: Block Kit
Install Time Hrs: 6-8
Difficulty Level 1-5: 3
Wheel Size: 17 X 9
Back Spacing: 4.5-5″
Max Tire Size: 37 X 12.50