Special order, Not returnable

2019-23 Ram 1500 w/o air suspension 3 inch BDS Suspendion Performance Elite Coilover Lift Kit

    Delivery time:Allow 2 to 4 weeks delivery
Add to cart
  • Description
  • More

Important Kit Notes

  • 1. Will not work with stock rims with a 12.50" wide tire, tire will rub the UCA at full steering lock. If the stock rim is reinstalled it will need to be with the stock size tire ONLY!
  • 2. Ball joint used is 500-1134, use this for replacement purposes if a new ball joint is ever needed. Ball joint is directional and must be installed with the 'dot' facing either inward or outward on the vehicle, otherwise damage may occur
  • 3. Vehicles equipped with Offroad or Rebel Package will not achieve full 3" of lift, net ride height change will be around 2" above stock.

BDS Suspension raises the bar for 2019+ RAM 1500 with new 3" coilover systems.

Designed to take advantage of the factory suspension geometry without overextending operating angles, these 3" system offer next level performance without the need to overhaul the suspension to correct the geometry like on the 4"+ kits. At the heart of these 3" systems are a pair of precision tuned FOX 2.5 performance elite series coilovers engineered to outperform on and offroad as they soak up the terrain. These coilovers are preset for the correct lift height right out of the box to provide optimal performance and direct bolt-in replacement for the factory strut assemblies. They feature a smooth bore and honed seamless aluminum body for better heat dispersion, 7/8" hardened steel carbon shaft, Eibach coil springs and black anodized machined 6061-T6 billet aluminum mounts along with remove reservoirs optional DSC (dual speed compression) adjustment technology built in. DSC allows for easy adjustment of the vehicle's suspension compression dampening so you can dial in the ideal ride performance to soak up the bumps, both large and small. The DSC has 12 adjustment points for the high speed compression as well as 10 adjustment points for the low speed compression allowing you to make large or small changes to further improve your performance. Adjustments can be made by simply twisting the knobs located on the end of the reservoir. No tools or shop adjustments needed, allowing you to tune the suspension out on the trail. A pair of reservoir mounting brackets are supplied to position the reservoirs. Complimenting the coilovers are a pair of performance upper control arms (UCAs) designed for improved strength and suspension travel. Built from thick wall 1.5" DOM tubing, these UCAs utilize an indexed ball joint cup to reposition the upper ball joints and allowing more droop travel. These arms come fully assembled right out of the box with high quality greaseable ball joints and rubber bushings for long life, quiet operation and superior corrosion resistance over uniballs and heims.

For the rear of these 3" systems the stance is leveled out with a pair of 1.5" ProRide dual rate coil springs to lift and provide a more level stance. Your choice of rear FOX 2.0 Performance Series IFP gas shocks or upgrade FOX 2.5 Performance Elite Series DSC reservoir shocks are offered to match the front for next level performance and easy tuning to meet the demands out on the trail. As with all BDS kits these come ready to install right out the box with all hardware packs and step-by-step installation instructions.

Improve the look and capability of your RAM 1500 truck with this 3" Coilover System from BDS Suspension.

Tire & Wheel Combinations
33x12.50 w/20x9 and 4.5-5" back spacing
33x12.50 w/18x9 and 4.5-5" back spacing
*Trimming may be required*

Est. Installation: 4 hours
Difficulty Level (easy 1 - 5 complicated): 3