BDS Suspension 6" Lift kit 2008 to 2010 Ford F250 / F350 Superduty

BDS:558H
Add to cart
  • Description
  • More

Normally ships within 72 hours

Important Kit Notes
1. Removal of the factory block is required.
2. Installation of the rear block kit will result in a "pre-runner" look with the rear of the vehicle 2" lower than the front. To get a level stance you must upgrade to the rear leaf spring option.
3. These trucks were manufactured with and without top mounted overload springs on the rear leaf springs. A top mounted overload is an extra leaf separate from the pack that set above the main leaf. You will need to identify which you have before ordering.
4. If your vehicle is equipped with a carrier bearing, you will need to order 123402 in the options section.
5. Although extremely rare, front driveline vibration may occur.
6. Front exhaust modification may be required to clear the front driveshaft on gas models.
7. U-bolts will not fit dually models.
8. Dropped pitman arm will not fit 10 lug wide track F350 models.


BDS Suspension 6" Suspension Lift Kit for 2008-2010 Ford F250/F350 4WD pickup trucks.
This kit centered around two Pro-Ride Coil Springs. The box kit includes two new radius arm drop brackets to put the stock radius arm back at factory angle which will maintain your stock driving characteristics. The kit also comes with a new steering stabilizer, anti-sway bar drop brackets, a dropped pitman arm for steering angle correction, a track bar relocation bracket to properly center your axle and bump stop extension.

The rear is lifted via a 5" block kit.

Choose between gas and diesel configurations, as well as plenty of upgrades and acessories when customizing your kit..

Tire & Wheel Combinations
37" x 13.50" w/17 x 9 and 4.5" back spacing
37" x 13.50" w/18 x 9 and 4.5" back spacing
37" x 13.50" w/20 x 9 and 4.5" back spacing
*Trimming may be required*

Est. Installation: 8 hours
Difficulty Level (easy 1 - 5 complicated): 3