Stocking item, 30 day return policy applies

2019-23 Ram 3500 Diesel w/o rear air 6 inch Radius Arm lift kit

BDS Suspension
BDS:1682H
lbs
    Delivery time:Normally ships within 48 hours depending on options chosen
Add to cart
  • Description
  • More

BDS Radius arm lift kit

7stock

Important Kit Notes

  • 1. T-case indexing ring available for 6-bolt and 8-bolt equipped models, check vehicle before ordering
  • 2. Will not fit Cab and Chassis models
  • 3. Will NOT fit rear air-ride equipped models
  • 4. Diesel models only
  • 5. Will NOT Fit Mega Cab Aisin Transmissions (8-bolt)
  • 6. Does not fit Dually Models with 8-bolt Transmissions (Aisin)


BDS Suspension expands its listings for the late model 2019+ RAM 3500 4WD Diesel trucks
Designed to improve the looks and performance of your new RAM, these kits include everything necessary to correctly lift them for improved offroad capability with room for larger tires while maintaining on-road handling.

Up front these systems use a pair of (diesel specific) progressive rate 6" coil springs to provide the extra height and smooth controlled performance in the harshest of terrains. A forged drop pitman arm is supplied to correct steering angles along with a HD bar drop bracket to re-center the front axle. A pair of sway bar drop brackets reposition the OE sway bar for optimal performance along with extended polyurethane bump stops to limit up travel and brake line brackets to allow full droop. To correct the front suspension geometry at the new height a pair of heavy duty replacement radius arms that bolt directly into the factory location. These new radius arms are massive upgrade to the factory stamped units, using tubular construction and a lower cam adjustment to dial in front end caster. Also supplied are your choice of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks for improved ride and performance.

At 6" of lift it is critical to correct the front driveline angle to maintain use of the 4WD. To do this BDS Suspension provides a heavy duty replacement transmission crossmember as well as a transfer case indexing ring to reposition the front driveline output to allow use of the factory drivelines. BDS offers these indexing rings for both the 6-bolt and 8-bolt equipped trucks. In the rear of the RAM 3500 kits a 5" block and u-bolt kit is used for a level-to-slightly tail-high stance while maintaing tow capacity. Finishing out the rear are a matching set of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks.

 

Tire & Wheel Combinations
37x12.50 w/20x9 and 4.5-5.625" back spacing
37x12.50 w/20x9 and 5.625 back spacing
*Trimming may be required*

Est. Installation: 8 hours
Difficulty Level (easy 1 - 5 complicated): 3