Special order, Not returnable

2019-23 Ram 3500 Diesel w/o rear air 8 inch 4-link Lift Kit

BDS Suspension
    Delivery time:Allow 2 to 4 weeks delivery
Add to cart
  • Description
  • More

BDS 4-link lift kit

2019-21 Ram 3500 4-Link Diesel 8 inch Lift Kit by BDS Suspension

Important Kit Notes

  • 1. Will not work with Mega Cab Models
  • 2. Not compatible with DRW models
  • 3. Will not work with cab and chassis
  • 4. Recoil Traction bars recommended
  • 5. Designed for use on diesel models only
  • 6. Will not fit trucks with rear airbags
  • 7. This kit requires the use of an aftermarket front driveshaft (not provided) in addition to the (provided) indexing ring kit - BDS122624 (6-bolt) or BDS122421 (8-bolt). Both must be installed, however due to variations between truck configurations we recommend installing the kit prior to taking measurements for the aftermarket front driveshaft to ensure correct length. Vehicle can be driven without front driveshaft. Kit was tested with a Drive Line Plus flange and driveshaft, however other high angle driveshaft options can be used.

Designed to improve the look and performance of your new RAM, these new kits join existing 2"/3"/4"/6" lift kit options offering improved strength, capability and handling at a new taller lift height. Kits include everything necessary to correctly lift them for improved offroad capability with room for up to 40" tires while improving overall vehicle handling.

Up front these systems use a pair of 8" diesel specific progressive rate coil springs to provide the extra height and smooth controlled performance in the harshest of terrains. A forged drop pitman arm is supplied to correct steering angles along with an HD bar drop bracket to re-center the front axle. A pair of sway bar drop brackets reposition the OE sway bar for optimal performance along with extended polyurethane bump stops to limit up travel and brake line brackets to allow full droop. To correct the front suspension geometry at the new height, the factory stamped steel radius arms are converted over to 4-link using a pair of 1/4" steel brackets and high strength upper and lower control arms designed to limit caster control throughout suspension travel for more predictable handling characteristics. Also supplied are your choice of BDS NX2 gas shocks or FOX 2.0 Performance Series IFP gas shocks for improved ride and performance.

At 8" of lift it is critical to make front driveline adjustments to maintain use of 4WD due to the increased operating angle. To do this, BDS Suspension provides a heavy duty replacement transmission crossmember as well as a transfer case indexing ring to reposition the front driveline output which will need to be used in combination with an aftermarket front driveshaft (not included with kit). In the rear of the RAM 3500 kits a 5" block and add-a-leaf kit along with longer u-bolt for a level-to-slightly tail high while maintaing tow capacity. Finishing out the rear are a matching set of BDS NX2 gas shocks or FOX 2.0 Performance Series IFP gas shocks. Get the look and the ride you are after with these new 8" 4-link systems from BDS Suspension.

Tire & Wheel Combinations
40x13.50 w/17x9 and 4.5-5.5" back spacing
40x13.50 w/20x9 and 4.5-5.5" back spacing
*Trimming may be required*

Est. Installation: 8 hours
Difficulty Level (easy 1 - 5 complicated): 4